Create sturdy roller-bearing axles using our axle stubs that are designed to weld on to a square metal shaft or convert your antique buggy axle to roller bearing by cutting off the ends and welding on these stub axles. These are precision machined of high tensile steel and come complete with timken bearing and seal assemblies. Allow 4 weeks for delivery. Size is measured on square body width. Comes in 1", 1 1/4", or 1 1/2" sizes. Complete set comes with 2- stub axles and 2- matched boxings, 2 - washers, and 2 - directionally threaded nuts.
- Axle widths: 1", 1 1/4", 1 1/2"
- Made of 4140 hot-rolled steel stock
- Approx 3 1/2" square body length
- The 1 1/4" - 1 1/2" axles are made of 1045 hot-rolled steel stock
Question: How can I install these?
Answer: We recommend that you cut both your existing axle and the stub axle at a 45 degree angle before welding them together. This gives more surface area to weld together for greater strength. We recommend that you cut the stub axle first and then use it as a guide for cutting the length and angle of the existing axle. *Make sure that you are installing the proper directionally threaded spindle: right hand threaded spindles go on the right side of the vehicle, left hand threaded spindles go on the left side of the vehicle (directions in relation to the driver's seat facing forward).